ASTM F3371 - 19 - Standard Specification for Polyolefin Pipe and Fittings for Drainage, Waste, and Vent Applications

ASTM F3371 - 19

Standard Specification for Polyolefin Pipe and Fittings for Drainage, Waste, and Vent Applications

Status : Current   Published : April 2019

Format
PDF

Format
HARDCOPY



1.1 This specification covers requirements for non-pressure polyolefin pipe and fittings for drainage, waste, and vent applications.

Note 1:  This specification does not include requirements for pipe and fittings intended to be used to vent combustion gases.

1.2 Pipe is produced in Schedule 40 and 80 IPS sizes, in metric sizes, and in DR IPS sizes for two polyolefins; polyethylene (PE) and polypropylene (PP).

1.3 The interchangeability of pipe and fittings made by different manufacturers is not addressed in this specification.

1.4 Pipe and fittings are joined by the heat fusion method (Practice D2657 for PP butt and saddle fusion, Practice F2620 for PE butt, saddle and socket fusion and Practice F1290 for polyolefin electrofusion) or by using mechanical or gasketed joints recommended by the pipe and fitting manufacturers.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.7  The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM F3371 - 19
TitleStandard Specification for Polyolefin Pipe and Fittings for Drainage, Waste, and Vent Applications
StatusCurrent
Publication Date01 April 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors DWV, drainage, drain pipes, installation, joints, pipe fittings, pipes, plastic pipes, polyethylene, polyolefin, polypropylene, thermoplastic polymers, traps (drainage), waste, waste disposal (building)
ICS23.040.20
PublisherASTM
FormatA4
DeliveryYes
Pages10
File Size136 KB
Price£42.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version