ASTM D3288/D3288M - 20 - Standard Test Methods for Magnet-Wire Enamels

ASTM D3288/D3288M - 20

Standard Test Methods for Magnet-Wire Enamels

Status : Current   Published : August 2020

Format
PDF

Format
HARDCOPY



1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined

1.3 The test methods appear as follows:

[This table has been removed.]

1.4 There is no known IEC equivalent document.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3288/D3288M - 20
TitleStandard Test Methods for Magnet-Wire Enamels
StatusCurrent
Publication Date01 August 2020
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors density, determined solids, effective solids, enamels-magnet wire, evaporative solids, flash point, infrared spectroscopy, magnet wire enamels, rotational viscometer, simulated stack loss, stack loss, viscosity
ICS25.220.50
PublisherASTM
FormatA4
DeliveryYes
Pages7
File Size103 KB
Price£42.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world