ASTM D4647/D4647M - 13(2020) - Standard Test Methods for Identification and Classification of Dispersive Clay Soils by the Pinhole Test

ASTM D4647/D4647M - 13(2020)

Standard Test Methods for Identification and Classification of Dispersive Clay Soils by the Pinhole Test

Status : Current   Published : February 2020

Format
PDF

Format
HARDCOPY



1.1 This test method presents a direct, measurement of the dispersibility and consequent colloidal erodibility of clay soils by causing water to flow through a small hole punched in a specimen. The results of the tests are qualitative and provide general guidance regarding dispersibility and erodibility. This test method is complemented by Test Method D4221.

1.2 This test method and the criteria for evaluating test data are based upon results of several hundred tests on samples collected from embankments, channels, and other areas where clay soils have eroded or resisted erosion in nature ( 1). 2

1.3 Three alternative procedures for classifying the dispersibility of clay soils are provided as follows:

1.3.1 Method A and Method C, adapted from Ref ( 1), classify soils into six categories of dispersiveness as: dispersibility (D1, D2), slight to moderately dispersive (ND4, ND3), and nondispersive (ND2, ND1).

1.3.2 Method B classifies soils into three categories of dispersiveness as: dispersibility (D), slightly dispersive (SD), and nondispersive (ND).

1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.5  Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D4647/D4647M - 13(2020)
TitleStandard Test Methods for Identification and Classification of Dispersive Clay Soils by the Pinhole Test
StatusCurrent
Publication Date01 February 2020
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors clay, clay (dispersive), collodial erodibility, dispersibility, dispersivity, dispersion, dispersive clays, erosion, pinhole, soils
ICS93.020
PublisherASTM
FormatA4
DeliveryYes
Pages11
File Size468 KB
Price£47.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


BSOL

Access, view and download standards with multiple user access, across multiple sites with BSOL