ASTM D7508/D7508M - 20 - Standard Specification for Polyolefin Chopped Strands for Use in Concrete

ASTM D7508/D7508M - 20

Standard Specification for Polyolefin Chopped Strands for Use in Concrete

Status : Current   Published : February 2020



1.1 This specification covers polyolefin chopped strands (fibers) for use in concrete.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3  The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM D7508/D7508M - 20
TitleStandard Specification for Polyolefin Chopped Strands for Use in Concrete
Publication Date01 February 2020
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors alkaline resistance, appearance, chopped strands, concrete, denier, equivalent diameter, fiber, polyolefin, tension (tensile) properties/tests, thickness, width
File Size85 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Develop a PAS

Develop a fast-track standardization document in 9-12 months

Worldwide Standards
We can source any standard from anywhere in the world


The faster, easier way to work with standards