ASTM D1635/D1635M - 19 - Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading 

ASTM D1635/D1635M - 19

Standard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading 

Status : Current   Published : November 2019

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of the flexural strength of soil-cement by the use of a simple beam with third-point loading.

Note 1:  For methods of molding soil-cement specimens, see Practice D1632.

1.2  Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. The SI units are presented in brackets.

1.2.1 The gravitational system of inch-pound units is used when dealing with inchpound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The rationalized slug unit is not given, unless dynamic (F = ma) calculations are involved.

1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.3.1 The procedures used to specify how data are collected/recorded or calculated in the standard are regarded as industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D1635/D1635M - 19
TitleStandard Test Method for Flexural Strength of Soil-Cement Using Simple Beam with Third-Point Loading 
StatusCurrent
Publication Date01 November 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors flexural strength, soil-cement, soil stabilization
ICS93.020
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size116 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Worldwide Standards
We can source any standard from anywhere in the world


BSOL

The faster, easier way to work with standards