ASTM D5151 - 19 - Standard Test Method for Detection of Holes in Medical Gloves

ASTM D5151 - 19

Standard Test Method for Detection of Holes in Medical Gloves

Status : Current   Published : October 2019

Format
PDF

Format
HARDCOPY



1.1 This test method covers the detection of holes in medical gloves.

1.2 This test method is limited to the detection of holes that allow water leakage under the conditions of the test.

1.3 The smallest hole size that will allow water leakage in a medical glove has not been determined and is beyond the scope of this test method.

1.4 The safe and proper use of medical gloves is beyond the scope of this test method.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D5151 - 19
TitleStandard Test Method for Detection of Holes in Medical Gloves
StatusCurrent
Publication Date01 October 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors detection, gloves, holes, medical
ICS11.140
PublisherASTM
FormatA4
DeliveryYes
Pages2
File Size52 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months