ASTM A1047/A1047M - 05(2019) - Standard Test Method for Pneumatic Leak Testing of Tubing

ASTM A1047/A1047M - 05(2019)

Standard Test Method for Pneumatic Leak Testing of Tubing

Status : Current   Published : September 2019

Format
PDF

Format
HARDCOPY



1.1 This test method provides procedures for the leak testing of tubing using pneumatic pressure. This test method involves measuring the change in pressure inside the tubing over time. There are three procedures that may be used, all of which are intended to be equivalent. It is a qualitative not a quantitative test method. Any of the three procedures are intended to be capable of leak detection and, as such, are intended to be equivalent for that purpose.

1.2 The procedures will produce consistent results upon which acceptance standards can be based. This test may be performed in accordance with the Pressure Differential (Procedure A), the Pressure Decay (Procedure B), or the Vacuum Decay (Procedure C) method.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3.1 Within the text, the SI units are shown in brackets.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM A1047/A1047M - 05(2019)
TitleStandard Test Method for Pneumatic Leak Testing of Tubing
StatusCurrent
Publication Date01 September 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors leak testing, pneumatic testing
ICS23.040.99
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size97 KB
Price£42.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


BSOL

Access, view and download standards with multiple user access, across multiple sites with BSOL


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version