ASTM A370 - 19e1 - Standard Test Methods and Definitions for Mechanical Testing of Steel Products

ASTM A370 - 19e1

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

Status : Current   Published : July 2019

Format
PDF

Format
HARDCOPY



1.1 These test methods 2 cover procedures and definitions for the mechanical testing of steels, stainless steels, and related alloys. The various mechanical tests herein described are used to determine properties required in the product specifications. Variations in testing methods are to be avoided, and standard methods of testing are to be followed to obtain reproducible and comparable results. In those cases in which the testing requirements for certain products are unique or at variance with these general procedures, the product specification testing requirements shall control.

1.2 The following mechanical tests are described:

[This table has been removed.]

1.3 Annexes covering details peculiar to certain products are appended to these test methods as follows:

[This table has been removed.]

1.4 The values stated in inch-pound units are to be regarded as the standard.

1.5 When this document is referenced in a metric product specification, the yield and tensile values may be determined in inch-pound (ksi) units then converted into SI (MPa) units. The elongation determined in inch-pound gauge lengths of 2 or 8 in. may be reported in SI unit gauge lengths of 50 or 200 mm, respectively, as applicable. Conversely, when this document is referenced in an inch-pound product specification, the yield and tensile values may be determined in SI units then converted into inch-pound units. The elongation determined in SI unit gauge lengths of 50 or 200 mm may be reported in inch-pound gauge lengths of 2 or 8 in., respectively, as applicable.

1.5.1 The specimen used to determine the original units must conform to the applicable tolerances of the original unit system given in the dimension table not that of the converted tolerance dimensions.

Note 1:  This is due to the specimen SI dimensions and tolerances being hard conversions when this is not a dual standard. The user is directed to Test Methods A1058 if the tests are required in SI units.

1.6 Attention is directed to ISO/IEC 17025 when there may be a need for information on criteria for evaluation of testing laboratories.

1.7  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM A370 - 19e1
TitleStandard Test Methods and Definitions for Mechanical Testing of Steel Products
StatusCurrent
Publication Date01 July 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors bend test, Brinell hardness, Charpy impact test, elongation, FATT (Fracture Appearance Transition Temperature), hardness test, Izod impact test, portable hardness, reduction of area, Rockwell hardness, tensile strength, tension test, yield strength
ICS77.140.01
77.040.10
PublisherASTM
FormatA4
DeliveryYes
Pages50
File Size1.131 MB
Price£64.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Customers who bought this product also bought

  • ASTM E562 - 19
    Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count