ASTM D3715/D3715M - 98(2019) - Standard Practice for Quality Assurance of Pressure-Sensitive Tapes

ASTM D3715/D3715M - 98(2019)

Standard Practice for Quality Assurance of Pressure-Sensitive Tapes

Status : Current   Published : August 2019

Format
PDF

Format
HARDCOPY



1.1 This practice contains uniform quality assurance provisions for pressure-sensitive tapes and establishes sampling plans and procedures for acceptance inspection.

1.2  Limitations: 

1.2.1 This practice only includes procedures for when an upper or a lower specification limit is given. It does not provide for double, both minimum and maximum, specification limits.

Note 1:  When double specification limits are given (applies to variables testing only), use may be made of Table C-3 and Example C-3 of ANSI/ASQC Z1.9.

1.2.2 The variables sampling plans apply to a single quality characteristic. Having obtained the sample and the responses to the physical property tests, acceptance is determined on one quality characteristic at a time. The process is repeated for each additional characteristic.

1.2.3 The variables sampling plans require that the response to each quality characteristic is normally distributed either directly or by transformation. If this is not known, the potential user of this practice should seek the counsel of someone with sufficient understanding of statistical techniques to provide that information.

1.3 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3715/D3715M - 98(2019)
TitleStandard Practice for Quality Assurance of Pressure-Sensitive Tapes
StatusCurrent
Publication Date01 August 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors pressure-sensitive tape, quality assurance, sampling, Acceptance criteria/testing, Conformance/conformity assessment, Defects, End-item examination, Pressure-sensitive tapes, Quality assurance (QA), Sampling, Surface analysis--pressure-sensitive tapes
ICS55.040
83.180
PublisherASTM
FormatA4
DeliveryYes
Pages6
File Size103 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Collaborate, Innovate, Accelerate.


Worldwide Standards
We can source any standard from anywhere in the world