ASTM D3675 - 19 - Standard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source

Find Similar Items

This product falls into the following categories.

You may find similar items within these categories by selecting from the choices below:

ASTM D3675 - 19

Standard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source

Status : Current   Published : August 2019

Format
PDF

Format
HARDCOPY



1.1 This is a fire test response standard.

1.2 This test method describes the measurement of surface flammability of flexible cellular materials.

1.3  This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.6 Specific information about hazards is given in Section 7.

Note 1:  There is no known ISO equivalent to this standard.

1.7 The values stated in SI units are to be regarded as the standard. The values stated in inch-pound units, in parentheses, are for information only and are approximations (see also IEEE/ASTM SI-10).

1.8  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3675 - 19
TitleStandard Test Method for Surface Flammability of Flexible Cellular Materials Using a Radiant Heat Energy Source
StatusCurrent
Publication Date01 August 2019
Descriptors Flexible Cellular Materials, Radiant Panel Heat Sources, Surface Flammability
ICS13.220.40
83.100
PublisherASTM
FormatA4
DeliveryYes
Pages11
File Size322 KB
Price£45.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Collaborate, Innovate, Accelerate.


Worldwide Standards
We can source any standard from anywhere in the world