ASTM D5035 - 11(2019) - Standard Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method)

ASTM D5035 - 11(2019)

Standard Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method)

Status : Current   Published : July 2019

Format
PDF

Format
HARDCOPY



1.1 This test method covers raveled strip and cut strip test procedures for determining the breaking force and elongation of most textile fabrics. Provision is made for wet testing.

1.1.1 The raveled strip test is applicable to woven fabrics while the cut strip test is applicable to nonwoven fabrics, felted fabrics, and dipped or coated fabrics.

1.2 This test method is not recommended for knitted fabrics or for other textile fabrics which have high stretch (more than 11 %).

Note 1:  For the determination of the breaking force and elongation of textile fabrics using the grab test and modified grab test procedures, refer to Test Method D5034.

Note 2:  For determination of the breaking force and elongation of some specific types of fabrics which use the strip test, refer to Specifications D579 and D580.

1.3 This test method shows the values in both inch-pound units and SI units. Inch-pound units is the technically correct name for the customary units used in the United States. SI units is the technically correct name for the system of metric units known as the International System of Units. The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values expressed in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D5035 - 11(2019)
TitleStandard Test Method for Breaking Force and Elongation of Textile Fabrics (Strip Method)
StatusCurrent
Publication Date01 July 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors breaking-strength, elongation, fabric, nonwoven-fabric, woven fabric
ICS59.080.30
PublisherASTM
FormatA4
DeliveryYes
Pages8
File Size113 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Collaborate, Innovate, Accelerate.


Worldwide Standards
We can source any standard from anywhere in the world