ASTM D3773/D3773M - 10(2019) - Standard Test Methods for Length of Woven Fabric

ASTM D3773/D3773M - 10(2019)

Standard Test Methods for Length of Woven Fabric

Status : Current   Published : July 2019



1.1 These test methods cover four options for measuring fabric length and are applicable to full rolls or bolts of materials.

1.2 There are four approved options of measuring length as follows:

1.2.1  Option A—Hand (Section 6).

1.2.2  Option B—Drum (Section 7).

1.2.3  Option C—Clock (Section 8).

1.2.4  Option D—Folding (Section 9).

1.3 The values stated in either SI units or in U.S. customary units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM D3773/D3773M - 10(2019)
TitleStandard Test Methods for Length of Woven Fabric
Publication Date01 July 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
File Size73 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Worldwide Standards
We can source any standard from anywhere in the world

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


The faster, easier way to work with standards