ASTM F3023 - 18 - Standard Test Methods for Evaluating Design and Performance Characteristics of Stationary Upright and Recumbent Exercise Bicycles and Upper and Total Body Ergometers

ASTM F3023 - 18

Standard Test Methods for Evaluating Design and Performance Characteristics of Stationary Upright and Recumbent Exercise Bicycles and Upper and Total Body Ergometers

Status : Current   Published : June 2018

Format
PDF

Format
HARDCOPY



1.1 These test methods specify procedures and equipment used for testing and evaluating stationary exercise upright and recumbent bicycles and ergometers for compliance to Specification F1250. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In the case of a conflict between this document and Specification F1250, Specification F1250 takes precedence.

1.2  Requirements—Stationary exercise bicycles and ergometers are to be tested for the parameters specified in Specification F2276 and Test Methods F2571 and the following parameters unique to this equipment:

1.2.1 Seat post construction and loading,

1.2.2 Handlebar construction and loading,

1.2.3 Pedal construction and loading,

1.2.4 Crank arm and enclosure entrapment,

1.2.5 Seat back support loading,

1.2.6 Stability,

1.2.7 Direct Drive Exercise Bicycle Pedal Endurance,

1.2.8 Warnings, and

1.2.9 Documentation.

1.3 This test method 2 contains additional requirements to address the accessibility of the equipment for persons with disabilities.

1.4  Units—The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM F3023 - 18
TitleStandard Test Methods for Evaluating Design and Performance Characteristics of Stationary Upright and Recumbent Exercise Bicycles and Upper and Total Body Ergometers
StatusCurrent
Publication Date01 June 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors accessibility, Americans with Disabilities Act (ADA), crank training equipment, disability, disabled, ergometer, ergometers, exercise bike, fitness, inclusive, recumbent exercise bike, UBE, universal
ICS97.220.30
PublisherASTM
FormatA4
DeliveryYes
Pages10
File Size142 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Collaborate, Innovate, Accelerate.


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version