ASTM F467 - 13(2018) - Standard Specification for Nonferrous Nuts for General Use

ASTM F467 - 13(2018)

Standard Specification for Nonferrous Nuts for General Use

Status : Current   Published : September 2018



1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.

1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1:  This specification is the inch-pound companion to Specification F467M; therefore, no SI equivalents are presented in the specification.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM F467 - 13(2018)
TitleStandard Specification for Nonferrous Nuts for General Use
Publication Date01 September 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
File Size119 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


The faster, easier way to work with standards

Develop a PAS

Develop a fast-track standardization document in 9-12 months