ASTM D1640/D1640M - 14(2018) - Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings

ASTM D1640/D1640M - 14(2018)

Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings

Status : Current   Published : September 2018

Format
PDF

Format
HARDCOPY



1.1 These test methods cover the determination of the various stages and rates of film formation in the drying or curing of organic coatings under laboratory controlled conditions of air temperature, (low, ambient and/or elevated) and/or humidity. Procedures for assessing drying under prevailing conditions of temperature and humidity in the shop and field are also described.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D1640/D1640M - 14(2018)
TitleStandard Test Methods for Drying, Curing, or Film Formation of Organic Coatings
StatusCurrent
Publication Date01 September 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors cure, curing, dry, drying, drying time, film formation
ICS25.220.60
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size73 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Collaborate, Innovate, Accelerate.


BSOL

The faster, easier way to work with standards