ASTM D5224 - 12(2019) - Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

ASTM D5224 - 12(2019)

Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

Status : Current   Published : May 2019

Format
PDF

Format
HARDCOPY



1.1 This practice covers the general principles to be followed when compression molding test specimens of thermosetting molding compounds, such as phenolics, aminoplastics, melamine phenolics, epoxies, and unsaturated polyesters.

1.2 Molding conditions are given for amino, phenolic, and allyl molding compounds. The exact molding conditions will vary from material to material, and, if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used

1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are given for information only.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:  This standard and ISO 295 address the same subject matter, but differ in technical content.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D5224 - 12(2019)
TitleStandard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds
StatusCurrent
Publication Date01 May 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors allyl molding compound, amino molding compound, compression molding, phenolic molding compound, plastics, thermoset
ICS77.180
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size174 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


BSOL

The faster, easier way to work with standards


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version