ASTM D3419 - 12(2019) - Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

ASTM D3419 - 12(2019)

Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

Status : Current   Published : May 2019

Format
PDF

Format
HARDCOPY



1.1 This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used and its plasticity.

Note 1:  The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This practice assumes the use of reciprocating screw injection molding machines.

Note 2:  This standard and ISO 10724 address the same subject matter, but differ in technical content.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3419 - 12(2019)
TitleStandard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
StatusCurrent
Publication Date01 May 2019
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors in-line screw-injection-molding, injection molding, test specimens, thermosetting compounds
ICS83.140.99
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size154 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Collaborate, Innovate, Accelerate.


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


BSOL

The faster, easier way to work with standards