ASTM D5813 - 04(2018) - Standard Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems

ASTM D5813 - 04(2018)

Standard Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems

Status : Current   Published : October 2018

Format
PDF

Format
HARDCOPY



1.1 This specification covers cured-in-place thermosetting resin pipe (CIPP), 4 through 132-in. (100 through 3353-mm) equivalent diameter, for use in gravity flow systems for conveying sanitary sewage, storm water, and certain industrial wastes. This specification is suited for the evaluation and testing of materials used in the rehabilitation of existing pipes by the installation and cure of a resin-impregnated fabric liner.

1.2 This specification can also be extended to cover manholes, pump stations, wetwells, vaults, storage tanks, and other similar structures where a cured in place liner using thermosetting resin is applicable.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Note 1:  There are no ISO standards covering the primary subject matter of this specification.

1.4  The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D5813 - 04(2018)
TitleStandard Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems
StatusCurrent
Publication Date01 October 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors cured-in-place pipe (CIPP), plastic pipe, thermoset, rehabilitation, thermosetting resin pipe, underground installation
ICS23.040.20
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size90 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world