ASTM G76 - 18 - Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets

ASTM G76 - 18

Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets

Status : Current   Published : October 2018

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments ( 1, 2). 2 Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range ( 3-5). Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.

1.2  Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard (exceptions below).

1.2.1  Exceptions: Table 1 uses HRB hardness. Footnote 7 and 11.2 use abrasive grit designations.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM G76 - 18
TitleStandard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets
StatusCurrent
Publication Date01 October 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors erosion, erosion rate, gas jet, metal erosion, solid particle
ICS77.060
PublisherASTM
FormatA4
DeliveryYes
Pages6
File Size259 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months