ASTM E1925 - 18 - Specification for Engineering and Design Criteria for Rigid Wall Relocatable Structures

ASTM E1925 - 18

Specification for Engineering and Design Criteria for Rigid Wall Relocatable Structures

Status : Current   Published : October 2018

Format
PDF

Format
HARDCOPY



1.1 This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and nonexpandable RWRSs. This specification applies to present engineering and design requirements for effective RWRSs that are operable in a variety of environments without degradation and are capable of all specified transport modes. This specification shall be applied to the design of expandable and nonexpandable RWRSs. This specification is a conversion of a military standard that was approved by all departments and agencies of the Department of Defense.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3  The following safety hazards caveat pertains only to the test required portion, Section 10, of this specification. This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM E1925 - 18
TitleSpecification for Engineering and Design Criteria for Rigid Wall Relocatable Structures
StatusCurrent
Publication Date01 October 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors adhesive bonded, aluminum, bonding, expandable, honeycomb sandwich panels, non-expandable, foam and beam panels, relocatable buildings, relocatable structures, rigid wall shelters
ICS91.060.10
PublisherASTM
FormatA4
DeliveryYes
Pages13
File Size351 KB
Price£45.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months