ASTM D3763 - 18 - Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

ASTM D3763 - 18

Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

Status : Current   Published : November 2018

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.

1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:  This standard and ISO 6603-2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3763 - 18
TitleStandard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
StatusCurrent
Publication Date01 November 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors falling weight, impact testing, plastics, puncture properties
ICS83.080.01
PublisherASTM
FormatA4
DeliveryYes
Pages10
File Size229 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


BSOL

The faster, easier way to work with standards


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version