ASTM D3376 - 18 - Standard Test Methods of Sampling and Testing Pulps to be Used in the Manufacture of Electrical Insulation

ASTM D3376 - 18

Standard Test Methods of Sampling and Testing Pulps to be Used in the Manufacture of Electrical Insulation

Status : Current   Published : November 2018

Format
PDF

Format
HARDCOPY



1.1 These test methods cover the sampling and testing of cellulosic pulps for use in the manufacture of electrical insulating papers and boards or in the direct application of pulp fibers as insulation to electrical conductors.

Note 1:  Consider the significance of any one pulp property test method, as set forth herein, with discretion depending on the product made from the pulp.

1.2 Sections on Reagents, Sampling, and Report are integral parts of each of the individual test methods that follow.

1.3 Each test method is described as being a measure of either a bulk property of the pulp or a property of a handsheet formed from the pulp.

1.3.1 Bulk characteristics determinable by these procedures appear in the following sections:

[This table has been removed.]

1.3.2 Handsheet characteristics determinable by these procedures appear in the following sections:

[This table has been removed.]

Note 2:  Methods for Ash, Silica, selected cations from Ash, Heat Stability, α, β, and γ Cellulose, Viscosity, Total Chlorine, Tear, and Dissipation Factor and Relative Permittivity, will be considered for addition as methods are developed.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D3376 - 18
TitleStandard Test Methods of Sampling and Testing Pulps to be Used in the Manufacture of Electrical Insulation
StatusCurrent
Publication Date01 November 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors water, tensile strength, solvent soluble matter, shive count, pulps, pH, pentosan content, moisture, Kappa/Permanganate number, handsheet machine, handsheet characteristics, freeness (Canadian Standard Freeness), folding endurance, fiber length of pulp, fiber analysis, extractable chlorides, extractable acidity-alkalinity, disintegration, dirt, conductivity, cellulosic fiber, cellulose, bursting strength, bulk characteristics, apparent density, ash content, air resistance ash analysis
ICS85.040
PublisherASTM
FormatA4
DeliveryYes
Pages10
File Size141 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Collaborate, Innovate, Accelerate.


BSOL

The faster, easier way to work with standards


Worldwide Standards
We can source any standard from anywhere in the world