ASTM D8156 - 18 - Standard Classification System for and Basis of Specifications for Thermoplastic Elastomer Copolyester Molding and Extrusion Materials

Related Standards

ASTM D8156 - 18

Standard Classification System for and Basis of Specifications for Thermoplastic Elastomer Copolyester Molding and Extrusion Materials

Status : Current   Published : June 2018

Format
PDF

Format
HARDCOPY



1.1 This classification system covers segmented block copolyester elastomers suitable for molding and extrusion.

1.2 This classification system allows for the use of segmented block copolyesther elastomers that are recycled provided that the requirements as stated in this classification system are met. The proportions of recycled material used, as well as the nature and amount of any contaminant, however, cannot be covered practically in this specification.

1.3 The properties included in this classification system are those required to identify the compositions covered. It is possible that there are other requirements necessary to identify particular characteristics important to specialized applications. One way of specifying them is by using the suffixes as given in Section 5.

1.4 This classification system and subsequent line callout (specification) are intended to provide a means of calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection is best made by those having expertise in the plastic field after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those covered by this classification system.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6  The following precautionary caveat pertains only to the test methods portion, Section 11, of this classification system. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:  This standard, ISO 14910-1, and ISO 14910-2 address the same subject matter, but differ in technical content.

1.7  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D8156 - 18
TitleStandard Classification System for and Basis of Specifications for Thermoplastic Elastomer Copolyester Molding and Extrusion Materials
StatusCurrent
Publication Date01 June 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Classification; classification system; copolyester; elastomers; line callout; recycle; specification
ICS83.080.20
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size148 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months