ASTM D2305 - 18 - Standard Test Methods for Polymeric Films Used for Electrical Insulation

ASTM D2305 - 18

Standard Test Methods for Polymeric Films Used for Electrical Insulation

Status : Current   Published : May 2018

Format
PDF

Format
HARDCOPY



1.1 These test methods cover the testing of homogeneous organic polymer films not over 2.4 mm (95 mils) thick that are to be used for electrical insulation.

1.2 These test methods are not necessarily applicable to testing films in combinations with a coating, another film, or with other types of substrate, such as fabrics or papers.

1.3 The values stated in SI units are the standard. The values in parentheses are provided for information only.

1.4 The procedures appear in the following sections:

[This table has been removed.]

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:  These test methods are similar to IEC 60674–2.

1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D2305 - 18
TitleStandard Test Methods for Polymeric Films Used for Electrical Insulation
StatusCurrent
Publication Date01 May 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Surface resistivity, Strain testing-electrical insulating materials, Polymer films, Plastic sheet and film, insulating materials, Permittivity (dielectric constant)-electrical, Perfluoro(ethylene-propylene)(FEP) copolymer, Heat-sealable polymeric films, Film, Electrical insulating plastics, Dielectric breakdown voltage, Corrosion, Conditioning-electrical insulating materials, Volume resistivity, Thickness, Tensile strength, Surface resistivity, Strain relief (shrinkage), Polymer films, Permittivity, High humidity, Heat-seal strength, Heat-sealable, Heat aging, Film, FEP fluorocarbon, Extractables, Elongation, Dissipation factor, Dielectric strength, Dielectric breakdown, Conditioning
ICS29.035.20
PublisherASTM
FormatA4
DeliveryYes
Pages8
File Size111 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Collaborate, Innovate, Accelerate.


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version