ASTM E2113 - 18 - Standard Test Method for Length Change Calibration of Thermomechanical Analyzers

ASTM E2113 - 18

Standard Test Method for Length Change Calibration of Thermomechanical Analyzers

Status : Current   Published : June 2018

Format
PDF

Format
HARDCOPY



1.1 This test method describes calibration of the length change (deflection) measurement or thermal expansion of thermomechanical analyzers (TMAs) within the temperature range from –150 °C to 1000 °C using the thermal expansion of a suitable reference material.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM E2113 - 18
TitleStandard Test Method for Length Change Calibration of Thermomechanical Analyzers
StatusCurrent
Publication Date01 June 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Calibration, Coefficient of thermal expansion, Deflection, Expansion, Expansivity, Thermal analysis, Thermal expansion, Thermomechanical analyzer (TMA)
ICS17.200.20
83.080.01
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size97 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Worldwide Standards
We can source any standard from anywhere in the world