ASTM D6117 - 18 - Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

ASTM D6117 - 18

Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

Status : Current   Published : June 2018

Format
PDF

Format
HARDCOPY



1.1 These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures.

1.2 The test methods appear in the following order:

[This table has been removed.]

1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.

1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:  There is no known ISO equivalent to this standard.

1.6  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D6117 - 18
TitleStandard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes
StatusCurrent
Publication Date01 June 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors mechanical fasteners, plastic lumber, plastic shapes, recycled plastics
ICS83.140.01
PublisherASTM
FormatA4
DeliveryYes
Pages9
File Size148 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world