ASTM D2645 - 07(2018) - Standard Tolerances for Yarns Spun on the Cotton or Worsted Systems

ASTM D2645 - 07(2018)

Standard Tolerances for Yarns Spun on the Cotton or Worsted Systems

Status : Current   Published : July 2018



1.1 These tolerances are applicable to all yarns spun on the cotton or the worsted system, either carded or combed, and composed of any fiber or mixture of fibers, except cotton tire cords and novelty or fancy yarns.

1.2 These tolerances are applicable only to yarns taken from packages, and not to yarns taken from greige or processed fabrics.

Note 1:  For tolerances for other spun yarns, see Tolerances D2644, Methods D179 and D738, and Specifications D541 and D681.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM D2645 - 07(2018)
TitleStandard Tolerances for Yarns Spun on the Cotton or Worsted Systems
Publication Date01 July 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Appearance, commercial mass, cotton system, extractable matter, strand, tolerance, twist, strength, unevenness, worsted system, yarn, yarn-number
File Size71 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version

Worldwide Standards
We can source any standard from anywhere in the world

Develop a PAS

Develop a fast-track standardization document in 9-12 months