ASTM C782 - 13(2018) - Standard Test Method for Softness of Preformed Tape Sealants

ASTM C782 - 13(2018)

Standard Test Method for Softness of Preformed Tape Sealants

Status : Current   Published : January 2018



1.1 This test method describes a laboratory procedure for determining the softness of preformed tape sealants.

Note 1:  Cone penetration methods applicable to greases and to petrolatum are described in Test Methods D217 and D937. Test Method D2451 also uses a penetration technique for determining the degree of set in sash glazing compounds.

1.2 The values stated in SI units are to be regarded as standard. Temperature values are also provided (in parentheses) in degrees Fahrenheit.

1.3 The subcommittee with jurisdiction is not aware of any similar ISO standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM C782 - 13(2018)
TitleStandard Test Method for Softness of Preformed Tape Sealants
Publication Date01 January 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Compression Test, Physical Properties, Preformed Tape Sealants, Softness
File Size62 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


The faster, easier way to work with standards

Worldwide Standards
We can source any standard from anywhere in the world

Develop a PAS

Develop a fast-track standardization document in 9-12 months