ASTM D1675 - 18 - Standard Test Methods for Polytetrafluoroethylene Tubing

ASTM D1675 - 18

Standard Test Methods for Polytetrafluoroethylene Tubing

Status : Current   Published : May 2018



1.1 These test methods cover procedures for testing polytetrafluoroethylene tubing for use as electrical insulation. The procedures appear in the following sections:

[This table has been removed.]

Note 1:  These test methods are similar but not identical to those in IEC 60684–2.

1.2 The values stated in inch-pound units are the standard except for temperature, which is stated in degrees Celsius. Values in parentheses are for information only.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 5.

1.4  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Standard NumberASTM D1675 - 18
TitleStandard Test Methods for Polytetrafluoroethylene Tubing
Publication Date01 May 2018
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Ac breakdown voltage, bending effects, inside diameter, melting point, penetration resistance, polytetrafluoroethylene, PTFE, specific gravity, strain relief (shrinkage), tubes, volatile content, wall thickness
File Size94 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


The faster, easier way to work with standards

Worldwide Standards
We can source any standard from anywhere in the world

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version