ASTM D6980 - 17 - Standard Test Method for Determination of Moisture in Plastics by Loss in Weight

ASTM D6980 - 17

Standard Test Method for Determination of Moisture in Plastics by Loss in Weight

Status : Current   Published : June 2017

Format
PDF

Format
HARDCOPY



1.1 This test method covers the quantitative determination of moisture by means of loss in weight technology down to 50 mg/kg (50 ppm) as it applies to most plastics.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 Specimens tested by this method will be hot, use caution when handling them after testing has been completed.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1:  There is no known ISO equivalent to this standard.

1.5  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D6980 - 17
TitleStandard Test Method for Determination of Moisture in Plastics by Loss in Weight
StatusCurrent
Publication Date15 June 2017
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Moisture determination, Plastics, Volatile content
ICS83.080.01
PublisherASTM
FormatA4
DeliveryYes
Pages6
File Size90 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Worldwide Standards
We can source any standard from anywhere in the world