ASTM D1000 - 17 - Standard Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications

ASTM D1000 - 17

Standard Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications

Status : Current   Published : July 2017

Format
PDF

Format
HARDCOPY



1.1 These test methods cover procedures for testing pressure-sensitive adhesive-coated tapes to be used as electrical insulation. These tapes are classified as follows:

1.1.1  Class 1—Non-elastomeric backings made from materials such as:

[This table has been removed.]

1.1.2  Class 2—Elastomeric backings that are characterized by both high stretch and substantial recovery. These backings are made from materials such as:

[This table has been removed.]

1.2 Test laminates of Class 1 and Class 2 backings according to Class 1 test methods.

1.3 The procedures appear in the sections indicated below and in alphabetical order:

[This table has been removed.]

Note 1:  These procedures apply to both Class 1 and Class 2 tapes except as noted above.

1.4 This is a fire-test response standard (see Section 104).

1.5 The values stated in SI units are the standard, unless otherwise noted. If a value for measurement is followed by a value in inch-pound or English units in parentheses, it is likely that the second value will only be approximate and it is for information only. The first stated value is the preferred unit.

Note 2:  These test methods are similar to IEC 60454–3, but may differ sometimes in some details.

1.6  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 3.

1.7  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D1000 - 17
TitleStandard Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
StatusCurrent
Publication Date01 July 2017
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Accelerated aging, Adhesion, Adhesive, Backing, Bond strength, Breaking strength, Conditioning, Dielectric breakdown, Electrical insulating tape, Elongation, Flagging, Flammability, High temperature testing, Insulation resistance, Length, Low temperature testing, Oil resistance, Pressure-sensitive adhesive tape, Puncture resistance, Thermosetting, Thickness, Unwind force, Voltage, Width
ICS29.035.20
PublisherASTM
FormatA4
DeliveryYes
Pages20
File Size479 KB
Price£47.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version