ASTM D2835 - 89(2017) - Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements

ASTM D2835 - 89(2017)

Standard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements

Status : Current   Published : July 2017

Format
PDF

Format
HARDCOPY



1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement.

1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency, and drying rate.

1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S. customary units may be approximate.

1.4 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.




Standard NumberASTM D2835 - 89(2017)
TitleStandard Specification for Lubricant for Installation of Preformed Compression Seals in Concrete Pavements
StatusCurrent
Publication Date01 July 2017
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Building Seals And Sealants, Concrete, Consistency, Lubricating Oils, Manufacturing Defects, Performance Characteristics, Preformed Compression Seals, Voids
ICS93.080.10
PublisherASTM
FormatA4
DeliveryYes
Pages3
File Size65 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


BSOL

The faster, easier way to work with standards