ASTM A276/A276M - 17 - Standard Specification for Stainless Steel Bars and Shapes

ASTM A276/A276M - 17

Standard Specification for Stainless Steel Bars and Shapes

Status : Current   Published : March 2017



1.1 This specification covers hot-finished or cold-finished bars except bars for reforging ( Note 1). It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The free-machining types ( Note 2) for general corrosion resistance and high-temperature service are covered in a separate specification.

Note 1:  For bars for reforging, see Specification A314.

Note 2:  For free-machining stainless bars designed especially for optimum machinability, see Specification A582/A582M.

Note 3:  There are standards covering high nickel, chromium, austenitic corrosion, and heat-resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B02.07 and may be found in Annual Book of ASTM Standards, Vol. 02.04.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.

Standard NumberASTM A276/A276M - 17
TitleStandard Specification for Stainless Steel Bars and Shapes
Publication Date15 March 2017
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Austenitic stainless steel, Austenitic-ferritic duplex stainless steel, Ferritic stainless steel, Martensitic stainless steel, Stainless steel bars, Stainless steel shapes
File Size97 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Develop a PAS

Develop a fast-track standardization document in 9-12 months


The faster, easier way to work with standards

Worldwide Standards
We can source any standard from anywhere in the world