ASTM D4623 - 16 - Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method. Three Component Borehole Deformation Gauge

ASTM D4623 - 16

Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method. Three Component Borehole Deformation Gauge

Status : Current   Published : December 2016

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of the ambient local stresses (principal and secondary) in a rock mass and the equipment required to perform in situ stress tests using a three-component borehole deformation gauge (BDG) that was developed by the U.S. Bureau of Mines (USBM); see Note 1.

1.2 The test procedure and method of data reduction are described, including the theoretical basis and assumptions involved in the calculations.

1.3 A section is included on troubleshooting equipment malfunctions.

Note 1:  The gauge used in this test method is commonly referred to by users as a USBM gauge (U.S. Bureau of Mines three-component borehole deformation gauge). 2

1.4 The values stated in inch-pound units are to be regarded as standard, except as noted below. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

1.5  This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM D4623 - 16
TitleStandard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method. Three Component Borehole Deformation Gauge
StatusCurrent
Publication Date01 December 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Borehole, Core, Deformation, Drilling, Gauge, In situ, Measurements, Moduli, Overcoring, Rock, Stress, USBM gauge
ICS93.020
PublisherASTM
FormatA4
DeliveryYes
Pages16
File Size540 KB
Price£45.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months