ASTM D7205/D7205M - 06(2016) - Standard Test Method for Tensile Properties of Fiber Reinforced Polymer Matrix Composite Bars

ASTM D7205/D7205M - 06(2016)

Standard Test Method for Tensile Properties of Fiber Reinforced Polymer Matrix Composite Bars

Status : Current   Published : November 2016

Format
PDF

Format
HARDCOPY



1.1 This test method determines the quasi-static longitudinal tensile strength and elongation properties of fiber reinforced polymer matrix (FRP) composite bars commonly used as tensile elements in reinforced, prestressed, or post-tensioned concrete.

Note 1:  Additional procedures for determining tensile properties of polymer matrix composites may be found in test methods D3039/D3039M and D3916.

1.2 Linear elements used for reinforcing Portland cement concrete are referred to as bars, rebar, rods, or tendons, depending on the specific application. This test method is applicable to all such reinforcements within the limitations noted in the method. The test articles are referred to as bars in this test method. In general, bars have solid cross-sections and a regular pattern of surface undulations and/or a coating of bonded particles that promote mechanical interlock between the bar and concrete. The test method is also appropriate for use with linear segments cut from a grid. Specific details for preparing and testing of bars and grids are provided. In some cases, anchors may be necessary to prevent grip-induced damage to the ends of the bar or grid. Recommended details for the anchors are provided in Annex A1.

1.3 The strength values provided by this method are short-term static strengths that do not account for sustained static or fatigue loading. Additional material characterization may be required, especially for bars that are to be used under high levels of sustained or repeated loading.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4.1 Within the text, the inch-pound units are shown in brackets.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM D7205/D7205M - 06(2016)
TitleStandard Test Method for Tensile Properties of Fiber Reinforced Polymer Matrix Composite Bars
StatusCurrent
Publication Date01 November 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Tensile properties, Tensile strength, Tensile modulus of elasticity, Bars, Composite materials, Composite bars
ICS91.100.40
PublisherASTM
FormatA4
DeliveryYes
Pages13
File Size298 KB
Price£45.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


BSOL

The faster, easier way to work with standards