ASTM B233 - 97(2016) - Standard Specification for Aluminum 1350 Drawing Stock for Electrical Purposes

ASTM B233 - 97(2016)

Standard Specification for Aluminum 1350 Drawing Stock for Electrical Purposes

Status : Current   Published : October 2016

Format
PDF

Format
HARDCOPY



1.1 This specification covers aluminum 1350 drawing stock 0.375 in. (9.52 mm) to 1.000 in. (25.40 mm) in diameter, in the tempers shown in Table 1, for drawing into wire for electrical conductors (Explanatory Note 1 and Note 2).

(A)  Applicable to stock sizes through 0.500-in. (12.70-mm) diameter. The values to apply for larger sizes in these tempers shall be negotiated at time of inquiry.

1.2 The SI values of density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.

Note 1:  Prior to 1975, aluminum 1350 was designated as EC aluminum.

Note 2:  The aluminum and temper designations conform to ANSI H35.1. Aluminum 1350 corresponds to unified numbering system A91350 in accordance with Practice E527.

(A)  Analysis shall regularly be made only for the elements specified in this table. If, however, the presence of other elements is suspected or indicated in amounts greater than the specified limits, further analysis shall be made to determine that these elements are not present in amounts in excess of the specified limits.
(A)  The equivalent resistivity values for 100 % IACS conductivity were each computed from the fundamental IEC value ( 1/ 58  Ω·mm 2/m) using conversion factors each accurate to at least seven significant figures. Corresponding values for other conductivities (aluminum) were derived from these by multiplying by the reciprocal of the conductivity ratios accurate to at least seven significant figures.
(A)  For this specification, mean diameter is the average of the maximum diameter and the minimum diameter measured in the same transverse plane along the length.






Standard NumberASTM B233 - 97(2016)
TitleStandard Specification for Aluminum 1350 Drawing Stock for Electrical Purposes
StatusCurrent
Publication Date01 October 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Aluminum, Aluminum drawing stock, Aluminum wire
ICS77.150.10
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size82 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version