ASTM G105 - 16 - Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

ASTM G105 - 16

Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

Status : Current   Published : June 2016

Format
PDF

Format
HARDCOPY



1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.

1.2 Abrasion test results are reported as volume loss in cubic millimetres. Materials of higher abrasion resistance will have a lower volume loss.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM G105 - 16
TitleStandard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
StatusCurrent
Publication Date01 June 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Abrasive wear test, Metallic materials, Rubber wheel, Scratching abrasion, Wet sand
ICS17.040.20
PublisherASTM
FormatA4
DeliveryYes
Pages9
File Size263 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


BSOL

The faster, easier way to work with standards


Collaborate, Innovate, Accelerate.