ASTM D5040 - 90(2016) - Standard Test Methods for Ash Content of Adhesives

ASTM D5040 - 90(2016)

Standard Test Methods for Ash Content of Adhesives

Status : Current   Published : May 2016



1.1 These test methods cover procedures used in determining the ash content of adhesives. This standard is intended as a replacement for Method 4032.1 of Federal Test Method Standard 175B, “Adhesives: Methods of Testing.”

1.2 Two test methods are used:

1.2.1  Test Method A is used for a starch adhesive or other type glue, where there is no danger from the non-volatile content forming a rubbery mass when ignited.

1.2.2  Test Method B employs nitric acid to avoid the non-volatile residue being transformed into a viscous foam when ignited.

1.3 These methods are not applicable to adhesives containing decomposable salts such as zinc chloride.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 9.2.3.

Standard NumberASTM D5040 - 90(2016)
TitleStandard Test Methods for Ash Content of Adhesives
Publication Date01 May 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Adhesive, Ash content
File Size60 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Worldwide Standards
We can source any standard from anywhere in the world


The faster, easier way to work with standards

Develop a PAS

Develop a fast-track standardization document in 9-12 months