ASTM D696 - 16 - Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between ?30°C and 30°C with a Vitreous Silica Dilatometer

ASTM D696 - 16

Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between ?30°C and 30°C with a Vitreous Silica Dilatometer

Status : Current   Published : April 2016

Format
PDF

Format
HARDCOPY



1.1 This test method covers determination of the coefficient of linear thermal expansion for plastic materials having coefficients of expansion greater than 1 µm/(m.°C) by use of a vitreous silica dilatometer. At the test temperatures and under the stresses imposed, the plastic materials shall have a negligible creep or elastic strain rate or both, insofar as these properties would significantly affect the accuracy of the measurements.

1.1.1 Test Method E228 shall be used for temperatures other than −30°C to 30°C.

1.1.2 This test method shall not be used for measurements on materials having a very low coefficient of expansion (less than 1 µm/(m.°C). For materials having very low coefficient of expansion, interferometer or capacitance techniques are recommended.

1.1.3 Alternative technique commonly used for measuring this property is thermomechanical analysis as described in Test Method E831, which permits measurement of this property over a scanned temperature range.

1.2 The thermal expansion of a plastic is composed of a reversible component on which are superimposed changes in length due to changes in moisture content, curing, loss of plasticizer or solvents, release of stresses, phase changes and other factors. This test method is intended for determining the coefficient of linear thermal expansion under the exclusion of these factors as far as possible. In general, it will not be possible to exclude the effect of these factors completely. For this reason, the test method can be expected to give only an approximation to the true thermal expansion.

1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1:  There is no known ISO equivalent to this standard.




Standard NumberASTM D696 - 16
TitleStandard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between ?30°C and 30°C with a Vitreous Silica Dilatometer
StatusCurrent
Publication Date01 April 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Coefficient of expansion, Linear expansion, Plastics, Thermal expansion
ICS83.080.01
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size121 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version