ASTM B228 - 11A(2016) - Standard Specification for Concentric-Lay-Stranded Copper-Clad Steel Conductors

ASTM B228 - 11A(2016)

Standard Specification for Concentric-Lay-Stranded Copper-Clad Steel Conductors

Status : Current   Published : April 2016



1.1 This specification covers bare concentric-lay-stranded conductors made from bare round copper-clad steel wires for general use for electrical purposes.

1.2 For the purpose of this specification, conductors are classified as follows: Grade 40 HS, Grade 30 HS, Grade 30 EHS, Grade 40 DSA, and Grade 30 DSA.

The grades covered by this specification correspond to the following commercial designations:

[This table has been removed.]

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard NumberASTM B228 - 11A(2016)
TitleStandard Specification for Concentric-Lay-Stranded Copper-Clad Steel Conductors
Publication Date01 April 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Clad steel electrical conductor, Concentric-lay-stranded copper-clad steel electrical, conductor, Copper-clad steel electrical conductor, Electrical conductor
File Size83 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


The faster, easier way to work with standards

Worldwide Standards
We can source any standard from anywhere in the world

Develop a PAS

Develop a fast-track standardization document in 9-12 months