ASTM D2911/D2911M - 16 - Standard Specification for Dimensions and Tolerances for Plastic Bottles

ASTM D2911/D2911M - 16

Standard Specification for Dimensions and Tolerances for Plastic Bottles

Status : Current   Published : April 2016



1.1 This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.

1.2  Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3  The following precautionary caveat pertains only to the test methods portion, Section 8 of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1:  There is no known ISO equivalent to this standard.

Standard NumberASTM D2911/D2911M - 16
TitleStandard Specification for Dimensions and Tolerances for Plastic Bottles
Publication Date01 April 2016
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Plastic, Bottles, Dimensions, Tolerances
File Size539 KB

 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents

Develop a PAS

Develop a fast-track standardization document in 9-12 months


The faster, easier way to work with standards

Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version