ASTM C873/C873M - 15 - Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds

ASTM C873/C873M - 15

Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds

Status : Current   Published : December 2015

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of strength of cylindrical concrete specimens that have been molded in place using special molds attached to formwork. This test method is limited to use in slabs where the depth of concrete is from 125 to 300 mm [5 to 12 in.].

1.2  Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ( Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure. 2)




Standard NumberASTM C873/C873M - 15
TitleStandard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds
StatusCurrent
Publication Date01 December 2015
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Compressive strength, Concrete, Cylinder molds, In-place strength
ICS91.100.30
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size176 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Develop a PAS

Develop a fast-track standardization document in 9-12 months


BSOL

The faster, easier way to work with standards