ASTM D3530 - 97(2015) - Standard Test Method for Volatiles Content of Composite Material Prepreg

ASTM D3530 - 97(2015)

Standard Test Method for Volatiles Content of Composite Material Prepreg

Status : Current   Published : November 2015

Format
PDF

Format
HARDCOPY



1.1 This test method covers the determination of the volatiles content, in weight percent of composite material prepregs. This standard focuses on composites with thermosetting resins that tend to lose a few percent of the matrix mass when heated due to loss of both retained water and low molecular weight matrix constituents that volatilize during heating.

1.2 Use of this test method is limited to maximum temperature of circulating air ovens (approximately 300°C).

1.3 Use of this test method is limited to temperatures below which the matrix flows from the reinforcement.

1.4 The values stated in SI units are to be regarded as standard.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.




Standard NumberASTM D3530 - 97(2015)
TitleStandard Test Method for Volatiles Content of Composite Material Prepreg
StatusCurrent
Publication Date01 November 2015
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Composite materials, Prepreg, Volatiles content
ICS59.100.30
PublisherASTM
FormatA4
DeliveryYes
Pages3
File Size65 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months