ASTM F1667 - 15 - Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

ASTM F1667 - 15

Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

Status : Current   Published : September 2015 Replaced By :

Format
PDF

Format
HARDCOPY



1.1 This specification covers nails, spikes, staples, and other driven fasteners, as listed in Table 1.

Note 1:  Fastener ductility information is presented in Table 2 and dimensional information in Tables 3–65.

(A)  All dimensions given in inches.
(A)  All dimensions are given in inches.
(A)  All dimension are given in inches.
(A)  All dimensions are given in inches.
(A)  All dimensions are given in inches.
(B)  Dashes (—) indicate that the fastener size is not a standard size.

 Editorially corrected in March 2012.

(A)  All dimensions are given in inches.
(B)  Dashes (—) indicate that the fastener size is not a standard size.

[This table has been removed.]

(A)  All dimensions are given in inches.
(B)  Root diameter is a calculated value and is not specified as a dimension to be measured.

[This table has been removed.]

(A)  All dimensions are given in inches.
(B)  Nails shall comply with the supplementary requirements of S1 and Table S1.1.
(C)  Nails identified as “ F1667 NLRSRS” must meet all applicable requirements of F1667 for the specified roof sheathing ring shank nail.
(D)  Individual rings shall be approximately frustrums, circular in transverse cross section, axially symmetric, and formed on the nail axis such that the minor diameter is closer to the nail point and the major diameter is closer to the nail head. The thread shall be continuous over the minimum thread length, TL min.
(A)  All dimensions are given in inches.

[This table has been removed.]

(A)  All dimensions are given in inches.

1.2 Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and are positioned by hand, tool, or machine.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 Fasteners in this specification are sold in bulk (loose) form and are collated for loading into the magazine of an application tool. Other than as covered in Section 9, Workmanship, cohering materials (including, but not limited to, plastic, adhesive bond, paper tape, plastic strip, plastic carrier, wire, etc.) and relative orientation of collated fasteners are not within the scope of this standard.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM F1667 - 15
TitleStandard Specification for Driven Fasteners: Nails, Spikes, and Staples
StatusCurrent
Publication Date01 September 2015
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Diameter, Driven fasteners, Head, Length, Nails, Point, Spikes, Staples
ICS21.060.01
PublisherASTM
FormatA4
DeliveryYes
Pages47
File Size2.229 MB
Price£64.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version


Collaborate, Innovate, Accelerate.


BSOL

The faster, easier way to work with standards