ASTM E255 - 07(2014) - Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

ASTM E255 - 07(2014)

Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

Status : Current   Published : January 2014

Format
PDF

Format
HARDCOPY



1.1 This practice describes the sampling of copper (except electrolytic cathode) and copper alloys in either cast or wrought form for the determination of composition.

1.2 Cast products may be in the form of cake, billet, wire bar, ingot, ingot bar, or casting.

1.3 Wrought products may be in the form of flat, pipe, tube, rod, bar, shape, or forging.

1.4 This practice is not intended to supersede or replace existing specification requirements for the sampling of a particular material.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.

1.6  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement appears in Appendix X4.




Standard NumberASTM E255 - 07(2014)
TitleStandard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
StatusCurrent
Publication Date12 January 2014
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Copper, Copper alloys, Sampling
ICS77.040.30
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size75 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Worldwide Standards
We can source any standard from anywhere in the world


Develop a PAS

Develop a fast-track standardization document in 9-12 months