ASTM F3131 - 14 - Standard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages

ASTM F3131 - 14

Standard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages

Status : Current   Published : January 2014

Format
PDF

Format
HARDCOPY



1.1 This specification covers basic characteristics required for porous laminated Epoxy materials intended for use as instrument and thin-section ball-bearing retainers (cages) and the methods of determining these characteristics.

1.2  Forms—Sheets and Rolled Tubes are recommended forms of laminated material covered by this specification.

1.3  Intended Use—Materials produced to this specification are intended for use as ball bearing retainers (cages). Temperature range is limited to 284°F (140°C) and below

1.4  Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM F3131 - 14
TitleStandard Specification for Epoxy / Cotton Raw Materials for the Use in Bearing Cages
StatusCurrent
Publication Date12 January 2014
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Ball bearing separator, Ball bearing cage, Epoxy, Fabricated, Laminated, Plastic
ICS21.100.10
PublisherASTM
FormatA4
DeliveryYes
Pages6
File Size92 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Worldwide Standards
We can source any standard from anywhere in the world