ASTM B952/B952M - 14 - Standard Specification for Zinc Alloys in Ingot Form for Spin Casting

ASTM B952/B952M - 14

Standard Specification for Zinc Alloys in Ingot Form for Spin Casting

Status : Current   Published : January 2014

Format
PDF

Format
HARDCOPY



1.1 This specification covers zinc alloys in ingot form for remelting for the manufacture of Spin Castings as specified and designated, as shown in Table 1. Seven alloy compositions are specified, designated as follows:

(A)  Per Practice B908.
(B)  For purposes of acceptance and rejection, the observed value or calculated value obtained from analysis should be rounded to the nearest unit in the last right-hand place of figures, used in expressing the specific limit in accordance with the rounding procedure prescribed in Practice E29.
(C)  ZA-73 is also often used as a pressure die casting alloy.

[This table has been removed.]

1.2 Zinc alloys #2, #3, #5, and ZA-8 specified in Specification B240 are also used in the spin casting process.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM B952/B952M - 14
TitleStandard Specification for Zinc Alloys in Ingot Form for Spin Casting
StatusCurrent
Publication Date10 January 2014
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Casting, Casting alloys, Centrifugical casting, Prototyping, Rubber mold, SC-A, SC-B, SC-C, Silicon mold, Spin casting, ZA alloys, Zamak, ZA-73, Zinc, Zinc-aluminum alloys
ICS77.150.60
PublisherASTM
FormatA4
DeliveryYes
Pages3
File Size67 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


BSOL

The faster, easier way to work with standards


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version