ASTM F2971 - 13 - Standard Practice for Reporting Data for Test Specimens Prepared by Additive Manufacturing

ASTM F2971 - 13

Standard Practice for Reporting Data for Test Specimens Prepared by Additive Manufacturing

Status : Current   Published : December 2013

Format
PDF

Format
HARDCOPY



1.1 This practice describes a standard procedure for reporting results by testing or evaluation of specimens produced by additive manufacturing (AM). This practice provides a common format for presenting data for AM specimens, for two purposes: (1) to establish further data reporting requirements, and (2) to provide information for the design of material property databases.

1.2 The values stated in SI units are required for all additive manufacturing related standards. However, when this standard is used in combination with any test method or equipment specified in inch-pound units the results should be reported with mathematical conversions to SI units immediately following in parentheses. The conversions shall be provided for information only and are not considered standard.

1.3  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM F2971 - 13
TitleStandard Practice for Reporting Data for Test Specimens Prepared by Additive Manufacturing
StatusCurrent
Publication Date15 December 2013
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Additive manufacturing, Reporting requirements, Test methods, Test specimens
ICS25.030
PublisherASTM
FormatA4
DeliveryYes
Pages4
File Size0 KB
Price£36.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Develop a PAS

Develop a fast-track standardization document in 9-12 months


Worldwide Standards
We can source any standard from anywhere in the world


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version