ASTM D7490 - 13 - Standard Test Method for Measurement of the Surface Tension of Solid Coatings, Substrates and Pigments using Contact Angle Measurements

ASTM D7490 - 13

Standard Test Method for Measurement of the Surface Tension of Solid Coatings, Substrates and Pigments using Contact Angle Measurements

Status : Current   Published : January 2013

Format
PDF

Format
HARDCOPY



1.1 This test method describes a procedure for the measurement of contact angles of two liquids, one polar and the other nonpolar, of known surface tension on a substrate, pigment (in the form of a disk), or cured or air dried coating in order to calculate the surface properties (surface tension and its dispersion and polar components) of the solid.

1.2 The total solid surface tension range that can be determined using this method is approximately 20 to 60 dyn/cm.

1.3 The values stated in CGS units (dyn/cm) are to be regarded as standard. No other units of measurement are included in this standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM D7490 - 13
TitleStandard Test Method for Measurement of the Surface Tension of Solid Coatings, Substrates and Pigments using Contact Angle Measurements
StatusCurrent
Publication Date07 January 2013
Normative References(Required to achieve compliance to this standard)No other standards are normatively referenced
Informative References(Provided for Information)No other standards are informatively referenced
Descriptors Adhesion, Contact angles, Dispersion and polar components of solid surface, tension, Solid surface tension, Wetting
ICS25.220.60
87.040
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size0 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Collaborate, Innovate, Accelerate.


Tracked Changes

Understand the changes made to a standard with our new Tracked Changes version