ASTM E1935 - 97(2013) - Standard Test Method for Calibrating and Measuring CT Density

Find Similar Items

This product falls into the following categories.

You may find similar items within these categories by selecting from the choices below:

ASTM E1935 - 97(2013)

Standard Test Method for Calibrating and Measuring CT Density

Status : Current   Published : January 2013

Format
PDF

Format
HARDCOPY



1.1 This test method covers instruction for determining the density calibration of X- and γ-ray computed tomography (CT) systems and for using this information to measure material densities from CT images. The calibration is based on an examination of the CT image of a disk of material with embedded specimens of known composition and density. The measured mean CT values of the known standards are determined from an analysis of the image, and their linear attenuation coefficients are determined by multiplying their measured physical density by their published mass attenuation coefficient. The density calibration is performed by applying a linear regression to the data. Once calibrated, the linear attenuation coefficient of an unknown feature in an image can be measured from a determination of its mean CT value. Its density can then be extracted from a knowledge of its mass attenuation coefficient, or one representative of the feature.

1.2 CT provides an excellent method of nondestructively measuring density variations, which would be very difficult to quantify otherwise. Density is inherently a volumetric property of matter. As the measurement volume shrinks, local material inhomogeneities become more important; and measured values will begin to vary about the bulk density value of the material.

1.3 All values are stated in SI units.

1.4  This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.




Standard NumberASTM E1935 - 97(2013)
TitleStandard Test Method for Calibrating and Measuring CT Density
StatusCurrent
Publication Date06 January 2013
Descriptors Computed tomography, Contrast sensitivity, CT density resolution, Density calibration, Linear attenuation coefficient, Mass attenuation coefficient
ICS19.100
35.240.80
PublisherASTM
FormatA4
DeliveryYes
Pages5
File Size0 KB
Price£40.00


 Your basket
Your basket is empty

Multi-user access to over 3,500 medical device standards, regulations, expert commentaries and other documents


Worldwide Standards
We can source any standard from anywhere in the world


Collaborate, Innovate, Accelerate.


27 November

Organizational Resilience Annual Conference 2019